This ranges from 1 to 5, 1 being the softest and 5 being the hardest acceleration. This allows you to adjust only the acceleration intensity of the front motor. This allows you to adjust only the acceleration intensity of the rear motor. The easiest way to explain this function is through video, please see the attached link: The default value is 30 percent but can be set anywhere from 0 percent to 100 percent. This allows you to control the battery percentage remaining where the scooter automatically switches over to ECO mode. The maximum allowable value is 110F/43C degrees. This allows you to adjust the maximum allowable temperature before the scooter automatically kicks back down to ECO mode. This allows you to adjust the maximum current allowed to both motors as a percentage. Please note to engage the cruise control while riding press and old the - button, you can then adjust the speed incrementally with the + or - keys This allows you to toggle the cruise control function On and Off The default value is 11 and for most tires commonly available for the Burn-E this value is accurate. You can adjust the tire size ( in inches) with this setting. The Burn-E is an extremely fast and heavy scooter, and accidental bump of the throttle could cause significant damage to surrounding objects and worse injury to others.

We highly recommend even for experienced riders that the ' Zero Start' function remain off. You can adjust if you want the scooter to be able to start directly via the throttle with no delay or if you would like it to start only after being pushed forward first. You can adjust the amount of magnets for a given motor to have the correct speed detection and motor commutation, there is no need to adjust this and it should be left at its default value of 30. You can adjust the voltage profile with this setting, this should be left a 72V for the Burn-E's please note to turn this feature off simply select past 30 and OFF will be displayed. This is where you can adjust the amount of time the scooter will stay on In minutes from 1 minute to 30 minutes if left idle. The scale is from 1-5, 1 being the lowest and 5 being the brightest. This is where you can adjust the brightness of the display backlight. An example of this would be limiting the speed and acceleration of the motors to have a inclement weather mode or A speed limited mode for inexperienced riders. This is where you select the ride mode you would like to configure, please note that you can change each ride mode independently to whatever characteristic you would like. You will now use the + or - keys to change the setting value and press the M button to save the selection. To change a setting use the + or - keys to scroll up and down through the available settings, when you reach the desired setting press the M button and the lower value will begin to blink.Double tap the M while in the P1 to enter the advanced settings ( P1.1, P1.2, P1.3, etc.).The ride mode will begin to flash and you can then select different ride modes by pressing the + or - keys. To select a ride mode to configure that is different than the current one press the M button while in the P1 menu,.Double Tap the M button to enter the P settings.Hello everyone, today I will be guiding you through the P settings on your Nami Burn-E Display.

Stop burn e